Snapper ST48 User Manual

ASSEMBLY
INSTALL THE UPPER SHAFT TO THE LOWER SHAFT
(See
Figures 4.1 and 4.2
)
WARNING
Never install, remove, or adjust any attachment while string trimmer is running.
Failure to stop the motor can cause serious personal injury.
The attachment connects to the power head by means of a coupler device.
1. 
2. Loosen the knob (1) on the coupler (5).
3. Push in the release button (2) located on the lower shaft (3). Align the
release button with the positioning hole (4) and slide the two shafts
together. Rotate the lower shaft until the button locks into the positioning
hole.
1
5
4
2
3
2
NOTE
: If the button does not release completely in the positioning hole, the
shafts are not locked into place. Slightly rotate from side to side until the
button is locked into place.
4. Tighten the knob securely.
Fig. 4.2
Loosen
Tighten
13
Fig. 4.1

Snapper ST48 Specifications

General

Brand	Snapper
Model	ST48
Category	Trimmer
Language	English