11
Features and Controls
Control Functions
The information below briefly describes the function of individual controls. Starting, stopping, driving, and
mowing require the combined use of several controls applied in specific sequences. To learn what combination
and sequence of controls to use for various tasks see the OPERATION section.
Forward Speed Control Lever
Reverse Speed Control Levers
These levers control the ground speed of the mower.
The forward speed control lever controls the forward ground
speed of both drive wheels.
The left reverse speed control lever controls the steering
and reverse ground speed of the left drive wheel. The right
reverse speed control lever controls the steering and reverse
ground speed of the right drive wheel.
See the Operation section for proper steering
instructions.
Ignition Switch
The ignition switch starts and stops the engine, it has two
positions:
OFF Stops the engine
RUN Rotate the ignition switch to the RUN
position before pulling on the starter rope
to start the engine.
Recoil Starter Handle
The recoil starter handle is used to start the engine.
Figure 2. Control Locations
To Next Page
Loading...
Need help?
General
