Sno-Way 22SKD Series - Disk Shoe Adjustment

10
Disk Shoe Adjustment
1. Raise the plow.
2. Place suitable blocking under plow to allow at least
10” of clearance to the ground.
3. Lower plow onto blocking.
.
4. Adjust shoe assemblies by removing Shoe Mounting
Pin and adding or subtracting washers on the top or
bottom of the shoe mounting bracket. (See Figure 1-22)
NOTE: Adjust shoe assemblies to meet surface condi-
tions. 1/4" to 1/2" off the ground for hard surfaces, 1" to 2"
for gravel roads, etc.
Figure 1-22
5. After the Disk Shoe position is properly adjusted,
place washers on the Disk Shoe Stem - above the Disk
Shoe Mounting Bracket, and below the Retaining Pin - to
remove all up and down movement of the Disk Shoe in
the Bracket. Failure to do this will result in excessive wear
of the holes in the Disk Shoe Mounting Bracket and will
also result in bending the Disk Shoe Stem.
WARNING
Keep hands and feet clear of blade and A-Frame
when setting blocking and lowering plow.
Moving or falling assemblies could result in
injury.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH.
WASHERS
PIN