4
Assembly
IMPORTANT: Graphics and illustrations may be
used which may show equipment and/or options not
included in every installation.
Assemble Blade and Swing Frame
(22 Series)
NOTE: The 22 series blade uses blade stops. Make sure
the proper stops are installed.
1. Open the carton and remove the blade parts bag.
The blade stops are in the blade parts bag.
2. Place stops between the lugs on the swing frame.
Secure with 3/8" x 1-3/4" bolts and locking nuts. (See
Figure 1-1). The bolts and nuts are in the blade parts
bag.
Figure 1-1
3. Lay blade face down on floor.
4. Place swing frame on blade, positioning the two
inside ribs between the swing frame lugs. insert a 3/4" x
1-5/8" clevis pin from blade parts bag to fasten each side.
(See Figure 1-2).
Figure 1-2
5. Insert washer on end of each clevis pin and secure
with cotter pin. Make sure cotter pin is properly bent or
pin may work loose. (See Figure 1-9)
Assemble Blade and Swing Frame
(26 Series)
1. Open the carton and remove the blade parts bag and
the trip stop bag. The blade parts bag contains the face
plates and stop blocks.
2. Slide the metal face plates into the blade stops from
the side. Place the stops between the lugs on the swing
frame. Secure with 3/8" x 2-1/2" bolts and locking nuts.
(See Figure 1-3). Bolts and nuts are in the blade parts
bag.
NOTE: The 26 Series blade uses green stops. Make sure
the proper stops are installed.
Figure 1-3
3. Lay blade face down on floor.
4. Install swing frame on blade, aligning the ribs on
either side of the center rib between the swing frame
lugs. Insert 3/4" x 2" clevis pins and washers from blade
parts bag through the mounting holes in the swing frame
and blade from the outside. (See Figure 1-4)
Figure 1-4
Insert washer on end of each clevis pin and secure with
cotter pin. Make sure cotter pin is properly bent or pin may
work loose. (See Figure 1-9)
3/8"x 1-3/4" BOLT
3/8"x 1-3/4" BOLT
3/8" NYLOCK NUT
3/8" NYLOCK NUT
3/4" x 1-5/8"
CLEVIS PIN
WASHER
WASHER
COTTER
PIN
COTTER
PIN
3/4" x 1-5/8"
To Next Page
Loading...