Sno-Way 22SKD Series - Assemble Blade and Swing Frame (29 Series); Assemble Blade and Swing Frame (32 Series)

5
Assemble Blade and Swing Frame
(29 Series)
1. Open the carton, remove the blade parts bag. Face
plates are in the bag with the stop blocks.
2. Slide the metal face plates into the slot in the blade
stops from the side. Place the stops between the lugs on
the swing frame. Secure with 3/8" x 2-1/2" bolts and
locking nuts. (See Figure 1-5) Bolts and nuts are in the
blade parts bag.
Figure 1-5
3. Lay blade face down on floor, using cardboard or
similar material to prevent paint damage.
4. Place swing frame on blade and insert 3/4" x 2" clevis
pin from blade parts bag. The ribs on either side of the
center rib should be between the swing frame lugs. (See
Figure 1-6)
Figure 1-6
5. Insert washer on end of clevis pin and secure pin with
cotter pin.
NOTE: Make sure cotter pin is properly bent or pin may
work loose. (See Figure 1-8)
Assemble Blade and Swing Frame
(32 Series)
1. Open the power pack carton and remove the blade
parts bag.
2. Lay blade face down on floor, using cardboard or
similar material to prevent paint damage.
3. Remove swing frame from box. Place swing frame on
blade and insert two 1" x 2" clevis pins from blade parts
bag. The ribs on either side of the center rib should be
between the swing frame lugs. (See Figure 1-7)
Figure 1-7
4. Secure each clevis pin with a 1" flat washer and 5/32"
X 1 3/4" cotter pin.
NOTE: Make sure cotter pin is properly bent or pin may
work loose. (See Figure 1-8)
Figure 1-8
3/8”x 2-1/2”
3/8” NYLOCK
3/8” NYLOCK
3/8”x 2-1/2”
BOLT
NUT
NUT
BOLT
STOP
FACE PLATE
SWING FRAME
SPRING
BRACKET
SPRING
BRACKET
STOP
FACE
PLATE
3/4” x 2"
CLEVIS PIN
WASHER
WASHER
COTTER
PIN
COTTER
PIN
3/4” x 2"
CLEVIS PIN
1” x 2"
CLEVIS PIN
FLAT
WASHERS
1” x 2"
CLEVIS PIN
COTTER
PINS
COTTER PIN
CLEVIS PIN