15
Disk Shoe Adjustment
1. Raise the plow to the UP position.
2. Place suitable blocking under plow to allow at least
10” of clearance to the ground.
.
3. Lower plow onto blocking.
4. Turn ignition switch OFF and apply the emergency
brake.
5. Adjust shoe assemblies by removing Shoe Mounting
Pin and adding or subtracting washers on the top or
bottom of the shoe mounting bracket. (See Figure 3-1)
NOTE: Adjust shoe assemblies to meet road conditions.
1/4" to 1/2" off the ground for hard surfaces, 1" to 2" for
gravel roads, etc.
Figure 3-1
6. After the Disk Shoe position is properly adjusted,
place washers on the Disk Shoe Stem - above the Disk
Shoe Mounting Bracket, and below the Retaining Pin - to
remove all up and down movement of the Disk Shoe in
the Bracket. Failure to do this will result in excessive wear
of the holes in the Disk Shoe Mounting Bracket and will
also result in bending the Disk Shoe Stem.
Cutting Edge
NOTE: Cutting Edge must be replaced when it is worn to
the bottom edge of the frame.
1. Raise the plow UP 8".
2. Place suitable blocking under A-Frame of plow to
allow at least 6” of clearance to the ground.
.
3. Lower plow onto blocking.
NOTE: If Plow is equipped with Lexan Blade the blade
must be retained prior to removing the Cutting Edge. This
can be accomplished by using a pair of 6" C-clamps
located at the center of the curved portion of the blade.
4. Remove mounting bolts holding old Cutting Edge to
blade. Discard old Cutting Edge and hardware.
5. Consult Parts Manual for proper replacement Cutting
Edge.
6. Install new Cutting Edge using new hardware.
WARNING
Keep hands and feet clear of blade and A-Frame
when setting blocking and lowering plow.
Moving or falling assemblies could result in
injury.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH.
WASHERS
PIN
WARNING
Keep hands and feet clear of blade and A-Frame
when setting blocking and lowering plow.
Moving or falling assemblies could result in
injury.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH.
CAUTION
Cutting edge may be sharp. Handle with care to
avoid injury.
To Next Page
Loading...
