Index
A
additional information, 1-2
aerial platform stability, 8-4
ambient air temperature operating range, 2-2
American National Standards Institute
(ANSI), 1-1, 3-1
ammeter, 5-1, 6-1
ANSI/NFPA 505, 3-2
B
batteries, 6-1, 8-1
battery charger, 6-1, 8-1
battery disconnect switch, 6-1, 9-1
cable ends, 8-1
charging, 3-3, 6-1
disconnect switch, 8-4
distilled water, 6-1, 8-1
general maintenance, 6-1
terminals, 8-1
water level, 6-1, 8-1
battery condition indicator, 7-2
battery disconnect switch, 7-1
brakes
brake disc, 9-3
brake pin, 9-3
disengaging, 9-3
release cam, 8-4
C
cables and wiring harness, 8-2
Canadian Standards Association
(CSA), 1-1
chassis controls, 7-1
battery disconnect switch, 7-1
component identification, 2-1
D
DC electrical motor, 8-2
drive motion alarm, 8-8
drive speed, 2-2
drive speeds, 9-2
drive system, 2-2
drive/lift level sensor, 2-2
drive/lift level sensor interlock, 4-2, 9-2
drive/lift pothole protector interlock, 4-2
drive/lift selector switch, 7-2
driving, 9-2
joystick, 9-2
transporting, 10-1
E
electrical hazard
see inside front cover
electrical power outlet, 4-3, 8-8, 9-4
accidental conductor grounding, 4-3
ground fault circuit interrupter, 4-3
electrical system, 2-2, 3-3, 8-1
battery terminals, 8-1
electrocution hazards, 3-1
minimum safe approach distance, 3-1
emergency lowering knob, 4-2
emergency operation
emergency lowering, 8-6, 11-1
lowering lever, 8-6, 11-1
towing, 11-1
emergency stop controls, 4-1
lower controls, 4-1, 8-4
upper controls, 4-1, 8-7
engine protection systems, 4-3
F
fasteners, 8-7
flashing light, 4-3, 8-6
free-wheeling valve, 8-3, 11-1
closing, 8-3
function speed, 2-2
G
general specifications, 2-2
ground clearance, 4-1, 8-5
ground fault circuit interrupter
reset button, 8-8
test button, 8-8
ground strap, 8-4
guardrail system, 4-3, 8-7
entry chain, 8-7
gravity gate, 4-3
mid rail, 4-3, 8-7
swinging gate, 4-3, 8-7
toeboards, 4-3, 8-7
top rail, 4-3, 8-7
H
hazardous (classified) location, 3-2
ANSI/NFPA 505, 3-2
hoisting
lifting devices, 10-3
lifting lugs, 10-3
sling cable, 10-3
spreader bars, 10-3
user responsibility, 10-3
horn, 4-3
button, 7-2
hoses, tubes, and fittings, 8-3
routing, 8-3
hour meter, 5-1
hydraulic system, 2-2, 3-3, 8-2
fluid level, 8-3
hydraulic pump, 8-2
I
interlock, 8-7, 9-2
S1930 – 0361266
To Next Page
Loading...
