EasyManua.ls Logo

SnowEx Bulk-Pro 1875 - User Manual

SnowEx Bulk-Pro 1875
51 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
© Trynex International 2009 (REV004) L1040
7 — 1
Spreaders for Snow & Ice Control
FOR MODELS
Bulk-Pro 1875
5701 orP-toviP
Mini-Pro 575
Junior 325
Rev. 05

Table of Contents

Questions and Answers

  • A
    alyssa38Aug 9, 2025
    What to do if my SnowEx Bulk-Pro 1875 Spreader motor doesn’t run?
    • J
      jennifermillerAug 9, 2025
      If the motor of your SnowEx Spreader isn’t running, there could be several reasons. It could be due to loose or poor electrical connections, so check and clean or replace them. A blown fuse could also be the cause, so replace the fuse. The motor may be seized, requiring replacement. A controller shutdown, possibly due to a jammed auger, could also be the reason; carefully clear any jammed material. Also check for electrical shorts or bare wires. If all else fails, the controller might have failed, and you may need to replace it.
  • L
    Lucas SchneiderAug 14, 2025
    Why is my SnowEx Spreader beeping and showing OL?
    • G
      Gavin KingAug 14, 2025
      If your SnowEx Spreader's audible alarm is beeping and the display shows 'OL', it indicates a jammed auger causing an overload shutdown. To resolve this, turn the spreader off for three seconds, then restart it. If the shutdown continues, turn off the controller and clear any debris and lumps from the auger areas.
  • R
    Richard HarperAug 19, 2025
    What to do if my SnowEx Bulk-Pro 1875 is beeping and showing EO?
    • M
      moniquesullivanSep 12, 2025
      If your SnowEx Spreader is beeping and the display shows 'EO', it means the motor isn't getting power. Turn the spreader off and check all connections to ensure they are properly connected.
  • D
    danielpotterAug 25, 2025
    What to do if my SnowEx Spreader is beeping and showing E1?
    • J
      jonathanrothAug 26, 2025
      If your SnowEx Spreader is beeping and the display shows 'E1', it indicates a short in the system. Turn the spreader off and do not use it until the problem is corrected.
  • A
    April PriceAug 29, 2025
    Why is my SnowEx Bulk-Pro 1875 beeping and showing LB?
    • G
      Gabriel SimpsonAug 29, 2025
      If your SnowEx Spreader is beeping and the display shows 'LB', it indicates that the vehicle battery is extremely low or there is a poor connection. Turn off the spreader and charge the battery.
  • K
    Kylie GuzmanSep 3, 2025
    Why is material not flowing from my SnowEx Bulk-Pro 1875 hopper?
    • R
      Ray JosephSep 3, 2025
      If material isn't flowing from your SnowEx Spreader hopper, it could be due to a few reasons. The hopper might be empty, so you should fill it. Alternatively, the material could be wet, in which case you should replace it with dry material. It could also be frozen or coarse, requiring replacement with suitable material.

SnowEx Bulk-Pro 1875 Specifications

General IconGeneral
ModelBulk-Pro 1875
MaterialPolyethylene
Power Source12V DC
Weight50 lb (empty)
Auger TypeSteel
Control SystemVariable speed