P.S : (1) Proximity reader provides two external relay connecting
points which are :
A. Anti-damage ( tamper switch and door sensor ) alarm
output connecting point ( 8P orange connecting point ).
B. Duress alarm output connecting point ( 8P yellow
connecting point ).
(2) If door sensor detecting (such as reed switch) connecting
points are to be applied, please set ALARM to the ON mode.
For setting method, please refer to setting mode functional
selection item 7 in the manual.
3. For installation, please secure power supply wire and control wire
through the base panel first and then fix the base panel onto the
wall.
4. Install the proximity reader on the base panel (power supply wire
and control wire must first be inserted and the wires must be
arranged correctly), then take the enclosed key wrench and
screws to mount it up.
5. Power supply: DC 12V 800mA.
6. Power consumption, standby 100mA, active 160mA.
7. Dimension: 160mm (L) X 100mm (W) X 30mm (H).
＊
In order to avoid electric lock and proximity main equipment to
operate together please do not share the power supply of
the electric lock and proximity main equipment.
VI.
PRECAUTIONS :
1. Before installation, please confirm the voltage and pole of the
power supply in order to avoid wrong connection causing damage
to the reader.
2. Please do not join the power supply together to the electric lock
and the proximity reader .
3. Please do not install metal product or monitor near this equipment
in order to avoid distance proximity.
4. Please do not conduct repair or do any modification to the system,
unless by qualified personnel
5. Warranty period for the reader is 1 year.
VII.
TROUBLESHOOTING
P. 15
To Next Page
Loading...