Socket 7 Series - Scanner Setup Procedures; Installing Batteries and Charging

11
iOS MODE
Connect Apple device in iOS Mode
Pl ease check wit h your scanner applicat ion vendor or visit
www.socketmobile.com/appstore to conrm your Scanner-enabled
applicat ion support s t he CHS.
Inst all t he scanner enabled soft ware.
If t he scanner-enabl ed Applicat ion does
not provide inst ruct ions on how t o connect wit h t he CHS, please use t he
following st eps.
1. Power on t he CHS. Make sure t he CHS is discoverable (unpaired).
2. To change the prole to iOS mode scan this barcode. The CHS will beep 3
t imes.
Use with iPad, iPod touch, and iPhones.
3. Turn Bluet oot h on t he Apple device. Go t o Set t ings > Bluet oot h.
A Bluet oot h Devices search will begin.
4. Tap Socket CHS[xxxxxx]* in t he list of Devices f ound. Aft er a few seconds
t he “ Not Paired” st at us will change t o “ Connect ed” and t he CHS Blue LED
will blink every 3 seconds conrming the connection.
*The charact ers in bracket s are t he last 6 charact ers of t he Bluet oot h Address.
The f ull Bl uet oot h address is print ed on t he Product label in bat t ery compart -
ment .
5. Open t he Scanner-enabled Applicat ion. The CHS will beep once indicat ing
t hat it is connect ed t o t he appropriat e applicat ion.
Now you are ready t o scan barcodes!