16
To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Hold the CHS about 4 inches (10 cm) from the barcode and press and hold the trigger
button. An aiming beam will appear for 3 seconds. Keep your hand steady while scanning.
For example, try scanning the following barcode:
After decoding the barcode and sending it to the computer, by default the CHS
will beep once and vibrate, the LED will flash green, and the aiming beam will
turn off. You can use the Command Barcodes
to modify the beep / LED / vibrate
settings.
By default, a carriage return is applied after scanned barcode data is entered. To
disable the automatic carriage return, you can use the Command Barcodes
(use
the Data Editing barcode for disabling suffixes).
If no data is read in a few seconds, the beam will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
After the iPad disconnects from the CHS, the soft keyboard will automatically
reappear within a few seconds.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last computer it
paired and connected to. Make sure your computer is in range with Bluetooth
enabled.
If the CHS is connected to your computer and gets disconnected, it will try to
reconnect. Make sure the computer is on and in range. If the CHS cannot reconnect
after several attempts, it will emit a long beep. Press the trigger button to restart the
reconnection process.
To Next Page
Loading...
