CHAPTER 3: SETUP FOR APPLE IOS 17
The CHS can only be paired with one device at a time. To use the CHS with a
different device, see Appendix F
for unpairing instructions.
Simultaneous Scanning and Soft Keyboard Support:
The CHS supports simultaneous use of the barcode scanner and the Apple iOS on-screen
keyboard while entering data into an application. This feature is enabled by default
and can be modified by scanning a special command barcode.
1. Connect the CHS to your Apple device.
2. Open your application and place the cursor where you want to enter data.
3. You can begin scanning barcodes. To open or close the onscreen keyboard, quickly
double-press the CHS power button (like double-clicking a mouse).
After you double-press the power button, the CHS will beep to indicate that the
onscreen keyboard was enabled / disabled.
Watch a video: http://www.youtube.com/watch?v=VhtttoC6ROs
To Next Page
Loading...
