Socket CHS Series 7 - Page 101

APPENDIX E: COMMAND BARCODES FOR CHS 7C 101
IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.
Automatic Reconnection Settings
ENABLE Automatic Reconnection from CHS (default)
Configures the CHS to automatically initiate a connection to the last paired computer /
device after the CHS is powered on.
IMPORTANT! After scanning this command barcode, power
off and power on the CHS
to make sure it is configured properly.
DISABLE Automatic Reconnection from CHS
Configures the CHS to wait for a computer / device to initiate a Bluetooth connection
after the CHS Is powered on.
IMPORTANT! After scanning this
command barcode, power off and power on the CHS
to make sure it is configured properly.
Factory Defaults
Factory Reset
Configures the CHS to revert all settings to factory defaults. The CHS will power off
after scanning this barcode.
Data Editing – Suffix
Data As Is
Configures the CHS to
return only the decoded
data (i.e., prefix and suffix
are not sent).
Suffix – Carriage Return
(default)
Configures the CHS to add
a carriage return at the
end of decoded data.
Suffix – Line Feed
Configures the CHS to add
a line feed at the end of
decoded data.
Suffix – Carriage Return
& Line Feed
Configures the CHS to add
a carriage return and line
feed at the end of decoded
data.
Suffix – Tab
Configures the CHS to add
a tab at the end of
decoded data
Compatible with all
revisions of CHS 7Ci and
Revision B or later
of the
CHS 7C