Socket CHS Series 7 - 2 Scanner Setup; Installing Batteries and Attaching the Tether

CHAPTER 2: SCANNER SETUP 11
2 | SCANNER SETUP
INSTALLING BATTERIES AND ATTACHING THE TETHER
1. Use a coin or screwdriver to unlock and remove the battery cover. Turn the lock underneath
the scanner to a horizontal position to unlock.
2. Remove the battery cover.
The Bluetooth Device Address (BDA) is printed on a label inside the battery compartment. It
helps you distinguish your CHS from other CHS scanners. If you install SocketScan 10, you
can also check the BDA in Scanner Settings.
3. Install the batteries in their correct positions, as indicated by the +/- symbols.
Revision Letter - follows Part Number (P/N)
Bluetooth Device Address
(BDA)