Socket CHS Series 7 - Bluetooth Mode Sequence; Simultaneous Use of CHS and Socket Plug-in Device

10
Vibrate
Vibrate
Meaning
Vibrate for 7Ci, 7P Power on OR data successfully scanned and sent to host device.
To modify the LED, beep and vibrate settings, you can use the Command Barcodes, or if the CHS
supports SPP mode for your OS, the Scanner Settings utility (see chapter for your OS).
Bluetooth Mode Sequence
When the CHS is powered on, its Bluetooth mode will gradually change if no connection is made.
Time after turning on CHS
Bluetooth mode
0-5 minutes
Discoverable and connectable
5-20 minutes
Connectable
20 minutes
CHS automatically powers off
Simultaneous Use of CHS and Socket Plug-in Device
You can use the CHS and a Socket plug-in barcode / RFID / magnetic stripe reader simultaneously on the
same host computer or device. However, you will need to run two different versions of SocketScan
concurrently.
• For the CHS, use SocketScan 10, which you can download from:
http://www.socketmobile.com/support/downloads/data-collection/series7/ss10/
• For Socket plug-in devices, use SocketScan 7 (or older), which you can download from:
http://www.socketmobile.com/support/downloads/data-collection/series5/
• For more information about Socket plug-in devices for data collection, please visit:
http://ww1.socketmobile.com/products/handheld-computers/accessories-hc.aspx?cat=Data%20Collection