CHAPTER 4: SETUP FOR WINDOWS MOBILE 35
OPTION 1: USING THE CHS IN HID MODE
To pair the CHS with your SoMo:
You only need to pair the CHS with your SoMo the first time you try to connect.
1. Power on the CHS. Press and hold the small power button until the LED turns blue and the
CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is on but not
connected.
2. Scan this barcode to configure the CHS for HID mode for peripherals. Afterwards, the CHS will
beep 3 times.
IMPORTANT! Print out this page to scan the barcode. Do not scan it onscreen.
The CHS must be in HID mode first before you scan the barcode above. By default, the CHS is in
HID mode. If the CHS was changed to SPP mode, use the Command Barcodes
to change it to
HID mode.
3. In the Today screen, tap on the line that lists Wi-Fi and Bluetooth status.
Alternatively, press the button on the right side of the SoMo, which launches the wireless
manager by default.
To Next Page
Loading...
