7 | SETUP FOR BLACKBERRY 87
To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Press the trigger button to scan a barcode. Make sure the aiming beam extends across the
entire width of the barcode.
For example, try scanning the following barcode:
IMPORTANT! Print out this page to scan the barcode. Do not scan it onscreen.
After decoding the barcode and sending it to the phone, by default the CHS will beep
once, the LED will flash green, and the aiming beam will turn off. The CHS 7Ci and 7P
will also vibrate to indicate that the barcode is decoded. You can use the Scanner
Settings utility (see next page) or Command Barcodes
to modify the beep / LED /
vibrate settings.
To configure an automatic Carriage Return or Tab after each scan of data, use the
Scanner Settings utility (see next page) or Command Barcodes
.
If no data is read in a few seconds, the beam will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds, until
the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last phone it paired and
connected to. Make sure your phone is in range with Bluetooth enabled and SocketScan 10 is
running.
If the CHS is connected to your phone and gets disconnected, it will try to reconnect for a few
minutes. Make sure the phone is on and in range. If the CHS cannot reconnect, you will hear a
long beep. Power cycle the scanner to restart the reconnection process.
The CHS can only be paired with one device at a time. To use the CHS with a different
device, see Appendix G
for unpairing instructions.
To Next Page
Loading...
