16
！ Caution
Please note that the dangerous operating range of the machine may extend depending on
the size of workpiece (because the workpiece may be swung around). Never step in such
extended operating range during operation.
It is very dangerous and strictly prohibited.
Before entering in the operation, confirm no tools, jigs or other unnecessary objects being
left over in the operating range.
It could break down the machine or cause a physical injury.
6 Maintenance, inspection
: Prohibition
Partial modification on the units, etc. are strictly prohibited.
It could cause a fire, trouble or malfunction.
Never weld something directly to the machine.
It could cause a trouble or malfunction.
It is prohibited to change the internal setting of printed circuit boards or internal setting of
parameters.
It could cause a malfunction.
！ Danger
Before installing or removing units, parts, etc., turn off the power supply (including the
primary power supply) and wait for 5 minutes.
Negligence of this precaution could cause an electrical shock or trouble.
Make sure to turn off the power supply before replacing batteries.
Negligence could cause an electrical shock or trouble.
Shut down the power supply (including the primary power supply) before starting the daily
inspection.
There is a risk of electrical shock if the machine is inspected while it is live.
！ Caution
It is necessary to display sign boards warning “Don’t turn on the power” or “Don’t turn on
To Next Page
Loading...