6
off.
Don’t touch them minimum 5 minutes after the main power supply is shut down.
Provide a power supply for the equipment in compliance with the electrical equipment
engineering standard and the extension wiring regulations.
Make sure to ground the equipment by means of the one-point grounding of Class 3 or
higher grade.
Don’t place a device which may raise noises, around the equipment, It is very
dangerous because noises may be picked up and cause a malfunction of the equipment.
Be careful not to damage, apply undue stress to or nip the cables, There is a risk of
malfunction or electrical shock.
Utmost attention should be paid neither to touch any moving or revolving part of the
equipment on which power is turned on, nor step in within the reach of moving part. There
is risk of physical injury.
Before starting the operation, make sure no tools, jigs, etc. are left over around the
machine or nobody but the operator is present within the operating range.
While the machine is operating, utmost attention is called for on the following moving
devices:
It is strictly prohibited to bring hands or part of body within the reach of these moving sections.
There is a risk of death or serious injuries such as a severing, broken bone, etc.
TB-38
To Next Page
Loading...