socomec DIRIS Digiware M-50 - SNMP Configuration via Embedded Webserver

47EN
DIRIS Digiware M-50 & M-70 - 548751B - SOCOMEC
Trapconguration: Choose to deactivate or activate the traps. If activated, you can choose to broadcast trap
notications to all supervisers on the network or to notify only specic host stations (up to 2).
Trap Host 1 IP: Enter the IP address of the 1st host station which will receive trap notications.
Trap Host 1 port: Enter the port used to send traps for the 1st host station.
Trap Host 2 IP: Address: enter the IP address of the 2nd host station which will receive trap notications.
Trap Host 2 port: Enter the port used to send traps for the 2nd host station.
Trapnoticationcycle: Enter the time after which a trap reminder will be sent for active alarms. By default, it is set to
60min.
15.7. SNMP conguration via the embedded webserver
Click on the “Wrench” icon on the top left corner and click on “Protocols”:
Click on the “Field protocols” tab, and under “Communication”, scroll down to the SNMP part to enter SNMP V1/V2 or
V3 settings, as well as Trap notications: