socomec DIRIS Digiware M-50 - Annex C: FTP Configuration; FTP Server Activation Steps

56 EN
DIRIS Digiware M-50 & M-70 - 548751B - SOCOMEC
17. ANNEX C
FTP CONFIGURATION
Measurement logs (see “4.2.2. Introduction to DIRIS Digiware M-70”, page 9) can be automatically exported via FTP(S).
17.1. FTP server activation:
Connect to the web server and go to the “Protocols” menu:
Click on “Data Push”.
Authenticationpart:
Site Name & Server Name: used to identify from which DIRIS Digiware M-50/M-70 the les are being exported.
The default site name is “SITE” (must be modied if the exoirt mode is set to EMS) et the default server name
corresponds to the NET ID marked on the front face of the M-50/M-70 gateway.