SodaStream JUMBO 13 - Connection of CO2 Tube; Use; First Start-Up

mod. JUMBO 13 - man. rev. 00
page 11 of 24
Manual of SODASTREAM Professional SRL Unipersonale. No reproduction allowed without previous authorization by
the owner.
Connection of CO2 tube
Insert the CO₂ tube, previously connected to the reducer of the CO₂ cylinder, into the
CO₂ inlet of the cooler and slightly pull it to verify it holds correctly.
Use
First start-up
Warning: with the cooler switched off, fill the internal tank until copper coils
are covered (1) (if water leaks from the “too full” drain on the front of the
cooler, the cooler not being inclined, it means the maximum admissible level
of water in the tank was exceeded)
1