mod. JUMBO 13 - man. rev. 00
Manual of SODASTREAM Professional SRL Unipersonale. No reproduction allowed without previous authorization by
the owner.
Warning: During first
installation it is necessary to
allow air to escape from the
circuit as described below:
Open the top cover
unscrewing the fixing
screws;
Set the CO
2
dispensing
regulating the reducer to the
desired value.
Lift the dedicated metallic
ring [1] of the carbonator for
3 seconds
Dispensing during first use
Warning Dispense 3 liters of cold still water and 1 liter of cold sparkling water
to clean water coils properly
Still water is immediately ready.
The ideal temperature for cold still and cold sparkling water will be reached
after approximately 3 hours.
Warning Periodically check the water level in the main tank. Should this level
not reach the MAX level, restore the level by adding water directly to the tank
as described in paragraph "first start-up”
Water temperature
We recommend setting the knob on the max level for best performance in
any environmental condition.
The temperature of cold still and cold sparkling water can be regulated
rotating the knob on the right side of the cooler.
The range of values indicates the output temperature, with “0” the water
will be refrigerated at minimum, with “MAX” the water will be refrigerated at
maximum.
To Next Page
Loading...