Sofar solar SOFAR 7.5KTLM - 6.3. Main Interface

SOFAR 7.5KTLM User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 45 -
6.3. Main Interface
Normal
------Press “back”
1.Enter Setting
2.Event List
3.SystemInfo
4.Display Time
5.Software Update
(A)
“
Enter Setting
”
Interface as below:
1.Enter
Setting
------Press “back”
1.Set time
12.Set Safety Voltage
2.Clear Energy
13.Set Safety Frequency
3.Clear Events
14.Set Insulation
4.Set Country
15.Set Reactive
5.On-Off Control
16.Set Power Derate
6.Enset country
17.Set Reflux
7.Set Energy
18.MPPT Scan
8.Set Address
19.StartTime
9.Set Input mode
20.Set ElecMeter
10.Set Language
21.Logic interface
11.Set Start Parameter
22.Set Power Ratio
1. Set Time
Set the system time for the inverter.
2. Clear Energy
Clean the inverter of the total power generation.
3. Clear Events
Clean up the historical events recorded in the inverter.
4. Set Country
Set up the safety regulation country that meets the current use conditions and
requirements. Before setting this item, ensure that the “Enable Set Country”option
are enabled . Please refer to “7.enable Set Country” for details.
Table 6-1 country code setting
*Mark serial number for temporarily can not set safety regulations country