All rights reserved Shenzhen SOFARSOLAR Co ., Ltd.
C
49
All rights reserved Shenzhen SOFARSOLAR Co ., Ltd.
C
50
SOFAR 10K~20KTL
User manual
SOFAR 10K~20KTL
User manual
Enset Country
7 . Set Energy
6. Enset Country
Set Energy
8
In
9
Sofar 10K～20KTL
and rekey in the correct passwords.It will enter into ''Power on&Power off'' interface if the
passwords is correct,then you can select ''Power on'' or ''Power off'' by pressing ''Up''
button or ''Down'' button and press ''OK'' button to finish the setting successfully.If you
select ''Power off'',need to set how many days you want the inverter to power off,increase
or decrease value though pressing ''Up'' button or ''Down'' button.After you set ''Power off''
successfully,you need to contact manufacturer to supply passwords to re-power on this
inverter.
On-Off Control
Users press ''Back'' button to enter ''1.Enter Setting'' interface,Press ''OK'' button to enter
main setting interface.Enter ''5.On-Off Control'' by pressing ''UP'' button or ''Down'' button.
Press ''OK'' button and enter On-Off Control interface,press ''OK'' button and enter ''Input
Password'' Setting interface.Press ''OK'' button to set passwords (default:0001),increase or
decrease value though pressing ''Up'' button or ''Dwon'' button,press ''OK'' button to next
value setting.''Error! Try again'' will be displayed for wrong passwords.Press ''back'' button
User can check current country code in SystemInfo>>5. Country.
Note: Country code changing will take effect after inverter reboot.
6 . Enset Country
(default:0001)
UK-G59t
UK-G83
Ukraine
33
34
35
36
37
38
39
40
41
42
43
44
Brazil
Mexico
FAR Arrete23
Denmark Tr322
Wide-Range-60HZ
Ireland EN50438
Thailand PEA
Thailand MEA
LV-Range-50HZ
EU EN50549
South Africa
45
46
47
48
49
AU-WA
Dubai DEWG
Dubai DEWG MV
Taiwan
AU-VIC
100
101
102
103
104
AU-SA
AU-QLD
AU-VAR
AUSGRID
Horizon
*This inverter（offer to Australian Market) has Volt-watt modes enabled by default. Volt-var
settings can be enabled by enabling the country code 102 AU_VAR or specific country code
(AU-VIC, AUSGRID, AU-QLD, AU-SA or AU-WA). Changing the country code back to 02 AU will
disable the Volt-var settings
To Next Page
Loading...
