Sofarsolar SOFAR 3KTLM-G3 - Page 63

OPERATION OF THE DEVICE
SOFAR 3 ... 6KTLM-G3 63
3. Clear events
Deletes the historical events
recorded in the inverter
4. Set SafetyPara
Sets the country and standard
applicable to the current application
conditions and requirements.
Before setting this, ensure that the
“Activate country setting” option
has been activated. For further
information, see “7. Activate
country setting”
5. On-Off Control
Local control of inverter
6. Set Energy
Sets the total power generation.
7. Set Address
Enter the Modbus address (when
several inverters require
simultaneous monitoring), standard:
01
8. Set Input Mode
For the SOFAR inverter input mode,
either parallel mode or independent
mode may be selected. For devices
with an MPPT, the setting will have
no effect.
Default: independent mode.
9. Set Language
Sets the display language of the
inverter
10. Set Reflux P
Activates or deactivates the feed-in
power function of the inverter and
sets the maximum feed-in power.
This function must be used