ANSI/NEMA FL1 Chart
IPX-8 (up to 2 meter under water, not for diving)
26 degrees for throw, 82 degrees for flood
The above mentioned parameters are based on tests according to international flashlight testing
standards (ANSI/NEMA FL1) using one 4800mAh 21700 Li-ion battery in our laboratory. Results may
vary with different battery or under different environmental conditions. Operation temperature is 0°C
- 40°C.
Specifications:
1 X CREE XHP50D-HI LED
Working Voltage: 3.0V - 4.2V
Battery Options: One 21700 Li-ion battery or one 18650 Li-ion battery
Dimension: 156mm (length) × 46.5mm (head diameter)
Weight: 151 (without battery)
Flashlight body: Aerospace grade 6061 grade aluminum alloy, CNC manufactured to hard-anodized
anti-abrasive finish to get solid built body, anti-crash geometry and better heat exchange.
Toughened mineral glass lens
IPX8 Waterproof
USB Type-C Charging
Mode Memory: memorizes the last brightness level used in the general modes (Eco/Low/Med/High)
Advanced Temperature Regulation (ATR) technology: ATR will adjust the brightness level
automatically when the driver temperature reaches 50
℃
(122 °F) to prevent overheating
Power Indicator:
The LED indicator in the side switch shows the power status for 5 seconds after turning C8L on.
Green = remaining battery power is good.
Red = remaining battery power is poor (less than 30%).
Flashing Red = critical power, replace or recharge battery as soon as possible.