Battery Installation
Before first use, please unscrew the tail cap and remove the insulating paper. If the battery needs to be replaced,
make sure that the positive end of the new battery faces the flashlight head when you put it in.
Battery Level Indicator
The indicator shows the power status for 5 seconds after turning IF23 on.
Green = remaining battery power is good (70% - 100%).
Red = remaining battery power is poor (30% - 69%).
Flashing Red = critical power (less than 30%), please replace or recharge battery as soon as possible.
Charging
IF23 offers a USB type-C charging port for convenient charging. Please connect it with the included USB-A to
USB-C cable and use a USB power adapter (not included) with 5V/3A (max) output. The flashing red indicator
means charging, while the green indicator means charging completed.
Operation Instructions
SPOTLIGHT MODE:
ON/OFF: One-click the switch to turn the light on/off.
DIRECT ACCESS TO TURBO MODE: When the flashlight is on, quickly double-click the switch to activate Turbo mode.
DIRECT ACCESS TO STROBE MODE: When the flashlight is on Turbo mode, quickly double-click the switch to enter into
Strobe. Then double-click the switch to cycle through Strobe-SOS-Beacon, one-click the switch to return to previously used mode.
MOONLIGHT MODE: When the flashlight is off, press and hold the switch for over one second to access the moonlight mode.
CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the switch and it will, starting from the remembered
brightness level, automatically cycle through Low, Medium, and High. The mode is selected when the switch has been released.
RAMPING UP/DOWN: When the flashlight is on, hold and press the switch to change brightness steplessly (1lm ← → 4000lm).
Ramping changes its direction when the switch is being pressed again within 1.5 seconds. The LED flashes once when it reaches the
lowest or highest end of the ramp.
FLOODLIGHT MODE:
ON/OFF: One-click the switch to turn the light on/off.
DIRECT ACCESS TO TURBO MODE: When the flashlight is on, quickly double-click the switch to activate Turbo mode.
DIRECT ACCESS TO STROBE MODE: When the flashlight is on Turbo mode, quickly double-click the switch to enter into
Strobe. Then double-click the switch to cycle Strobe-SOS-Beacon, one-click the switch to return to previously used mode.
MOONLIGHT MODE: When the flashlight is off, press and hold the switch for over one second to access the moonlight mode.
CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the switch and it will, starting from the remembered
To Next Page
Loading...
