Power Indicator
The LED indicator in the side switch shows the power status for 5 seconds after turning SC21 Pro on.
Green = remaining battery power is good.
Red = remaining battery power is poor (less than 30%).
Flashing Red = critical power, replace or recharge battery as soon as possible.
Recharging
SC21 Pro offers a USB-C port for convenient recharging of its 16340 battery. Please connect it with the
included USBA to USBC cable and use a USB power adapter (not included) with 5V 1A. While charging
the LED power indicator flashes red. Once finished the indicator will turn green to indicate a full battery.
Operation Instructions
Quick Start
After putting a battery in the light and tightening the parts together, the light should quickly blink once
to confirm it has power and is now operational. After that, basic usage is simple:
Click to turn the light on or another click to turn it off.
- Hold the button to change brightness.
- Release and hold again to change brightness the other way.
That is all the user needs to know for basic use, but there are many more modes and features available
for people who want more.
Before reading the rest of this manual, it is recommended that users look at the Anduril UI diagram(s),
which should be provided along with the flashlight.
Button presses
Button presses are abbreviated using a simple notation:
- 1C: One click. Press and then quickly release the button.
- 1H: Hold. Press the button, but keep holding it.
- 2C: Two clicks. Press and release quickly, twice.
- 2H: Click, hold. Click two times, but hold the second press.
- 3C: Three clicks. Press and release quickly, three times.
- 3H: Click, click, hold. Click three times, but hold the final press.
The same pattern is used with higher numbers too. For example, 10C means ten clicks... and 10H
To Next Page
Loading...
