MIVI Technical Manual
REF: 379/4 2
IMPORTANT
1° READ CAREFULLY THIS MANUAL. THE
APPLICATION OF WARRANTY IS SUBJECTED
TO STRICT OBSERVANCE OF INSTRUCTIONS.
2° THE OFFSET ADJUSTMENT IN THE AIR
MUST BE THE FIRST TASK COMPLETED
WHEN THE MIVI IS INSTALLED ON ITS
MOUTING.
Clean and dry the vibrating rod of the viscometer in order to make
it neat and dry;
Install the sensor on the process and fix it with its screws; these
must be tightened at the nominal torque;
Be sure the process is empty. The rod must be vibrating in the air;
Power on the device and wait at least 30 minutes;
Follow the instructions given in § 3.1.1 and in the electronic device
manual delivered with the equipment.
3° PRACTICAL ADVICES AND IMPORTANT
WARNINGS ARE ALSO LISTED IN § 2.4.
To Next Page
Loading...