Your Softub Hydromate System has been designed to be simple to
operate and easy to maintain.
TEMPERATURE SETTING
By experimenting with different settings on the control panel, you will
find the temperature most comfortable for you. The thermostat will
automatically turn the tub on and off as the temperature falls below,
then reaches, the set temperature to maintain the water temperature
you have selected, 24 hours a day.
Your Softub Spa will automatically display the temperature of the water
in your spa, whenever the pump is on and has been running for 2
minutes continuously. A “P” will be displayed when the pump is not on,
to indicate that the water near the temperature sensors must be purged
to get an accurate reading of the water temperature. To display the
water temperature when “P” is showing on the display, press the
“JETS” button. After 2 minutes, the water temperature will be displayed.
To set the temperature, press the up or down arrow once to display the
current setting. Then, use the up (Λ) and down (V) arrows to adjust the
temperature to the setting you desire. The current temperature setting
will display for 5 seconds after the up or down buttons are pressed.
After this time has elapsed, the display will revert to displaying the
water temperature.
12
To Next Page
Loading...
