(GFCI)
The Softub cord is fitted with a Ground Fault Circuit Interrupter (GFCI),
a very important safety feature. The GFCI shuts off the electricity in a
fraction of a second if there is a short in the cord or the Hydromate. This
plug fits conventional 110-volt outlets found in most homes. If properly
wired 110-volt in wall GFCI outlets should operate normally with the
Softub GFCI. It is recommended that the GFCI be tested each time it is
unplugged and plugged back in or after any power outage. The test
procedures are as follows:
A. Push the TEST button on the GFCI. The light on the GFCI and the
light(s) on the control panel should go out. If any of the lights fail to go
out, DO NOT USE THE SOFTUB. UNPLUG THE HYDROMATE AND
CALL YOUR LOCAL SERVICING DEALER OR SOFTUB
TECHNICAL SUPPORT AT 1-800-711-5382.
B. If the GFCI tests are okay, firmly push the RESET button back into
place and the Hydromate should resume power. If the RESET button
fails to reset properly, or if power does not return to the Hydromate,
UNPLUG THE HYDROMATE AND CALL YOUR LOCAL SERVICING
DEALER OR SOFTUB TECHNICAL SUPPORT AT 1-800-711-5382.
C. If the GFCI trips by itself at any time, firmly press the RESET button
back into place and perform the above tests. If this happens more than
once, UNPLUG THE HYDROMATE AND CALL YOUR LOCAL
SERVICING DEALER OR SOFTUB TECHNICAL SUPPORT AT 1-800
-711-5382.
15
To Next Page
Loading...
