OPERATION (cont.)
Filtration*
The tub automatically runs if it determines that it requires filtration. When the tub
is running in the filtration cycle, the filter icon will glow. The digital controls are
set to run two 15-minute filtration cycles in a 24 hour period. These will run
every 12 hours and are set when the spa is first plugged in. The filtration cycle
will only run if there has been no heat call in the prior 12 hours. If there has
been a heat call, the filtration cycle will be skipped, saving you money.
*patented programming
Ozone*
(If your Softub is equipped with ozone)
Ozone is a gas that is used as an aid to the sanitizer in the water. Ozone helps
to oxidize any contaminants in the water. If your Softub is equipped with ozone,
the tub automatically cycles ozone into the water for the first 15 minutes of every
heat call as well as during a filtration cycle, should one be deemed necessary.
The ozone is controlled by a solenoid that automatically opens and closes an air
pathway to the body of water. In the event of a manual activation (depression of
the jets button) the ozone is automatically turned off and will not run until the
next heat call or filtration cycle. This prevents the immediate contact with ozone
as well as delaying the automatic opening of the air control, which leaves the
control of the air to the discretion of the user.
*patented design and programming
Air Control
The main air control valve is located on the control panel of the motor unit. To
open the air control, rotate the knob counter-clock-wise one quarter of a turn. To
close the air control, rotate the knob clockwise. Each jet can also be individually
directed by rotating the head of the jet. After using your tub the air control
should be turned off, so the addition of outside air does not slow the heating of
your tub.
See your Softub Dealer for optional jets which can customize your Softub Spa.
12
To Next Page
Loading...
