Sokkia SET330R3 - User Manual

Quick Start Guide
May 26, 2005 Page 1 of 2
SOKKIA SERIES 30R
SET230R3, SET330R3, SET530R3, SET230R, SET330R, SET530R, SET630R
Procedure
1. Turn on the instrument
2. Level the instrument
3. On your instrument press ESC to exit to the main menu
4. Press F4 (CNFG)
5. Press the down arrow to highlight Comms setup and press Enter.
6. Verify that the communication parameters match the following:
Baud rate: 9600bps
Data bits: 8bit
Parity: Not set
Stop bit: 1bit
Check sum: No
Xon/Xoff: No
7. Press ESC to go back to the Config screen
8. Press ESC to go back to the Main menu
9. Press F1 (MEAS) to go to the Measure screen
10. In FieldGenius start or open an existing project. Press the Main Menu button  Settings 
Instrument Settings. On the Instrument Settings screen, select Total Station.
11. Match the following on the Model and Communication screen.
12. Specify the EDM settings you want to use on the EDM Settings screen.

Sokkia SET330R3 Specifications

General

Angle Measurement Accuracy	3"
Laser Plummet	Yes
Working Temperature Range	-20°C to +50°C (-4°F to +122°F)
Waterproof Rating	IP54
Type	Total Station
Angle Measurement Minimum Display	1" / 5" selectable
Distance Range Reflectorless	500 m (1, 640 ft.)
Distance Accuracy with Reflector	±(2 mm + 2 ppm)
Distance Accuracy Reflectorless	±(3 mm + 2 ppm)
Display	LCD
Data Storage	10, 000 points
Distance Range with Reflector	3, 000 m (9, 840 ft.) with single prism