SolaX Power X1-2.5-S-D User Manual

5.4 Installation Steps
5.5 Connection of the Inverter
Preparation
PV String Connection
Step 1: Screw the wall bracket on the wall
Step 2: Match the inverter with wall bracket




Below tools are needed before installation.
X1series inverter have a couple of PV connector which can be connected to one-
string PV modules. Please select PV modules with excellent function and reliable
quality. Open circuit voltage of module array connected should be ＜Max.DC
(table as follow) input voltage : operating voltage should be within the MPPT
voltage range.
Installation tools : crimping pliers for binding post and RJ 45, screwdriver, manual
wrench and
a) Use the wall bracket as a template to mark the position of the 3 holes on the
wall.
b) Drill holes with driller, make sure the holes are deep enough (at least 50mm) for
installing and tight the expansion tubes.
c) Install the expansion tubes in the holes, and tight them. Then install the wall
bracket using the expansion screws.
d) Hang the inverter over the bracket, move the inverter close to it, slightly lay
down the inverter, make sure the 3 mounting bars on the back are fixed well with
the 3 grooves on the bracket.
a)
b)
c) d)
Table 3 Max. DC Voltage Limitation
Max.DC Voltage
600V 600V 600V
Warning!
PV module voltage is very high which belongs to dangerous voltage
range, please comply with the electric safety rules when connecting.
Warning!
Please do not make PV positive or negative ground!
Note!
Please follow the requirements of PV modules as below:
Same type; Same quantity; Identical alignment; Identical tilt.
In order to save cable and reduce the DC loss, we suggest installing
the inverter near PV modules.
5. Installation5. Installation
5.5.1 The Main Steps to Connect to the Inverter
1514
Model
X1-2.5-S-D
X1-2.5-S-N
X1-3.0-S-D
X1-3.0-S-N
X1-3.3-S-D
X1-3.3-S-N

SolaX Power X1-2.5-S-D Specifications

General

Brand	SolaX Power
Model	X1-2.5-S-D
Category	Inverter
Language	English