Connection Steps:
Step1.Make EPS wires.
1.1 Choose the appropriate wire(cable size: refer to picture below).
1.2 Reserve about 60mm of conductor material sectional area.
1.3 Remove 12mm of insulation from the end of wire.
1.4 Insert stripped wires into AC terminal and insure all conductor strands
are captured in the AC terminal.
1.5 Compress the AC terminal head by using a crimping pliers and screw down
screw cap tightly.
Step2. Insert EPS cable into EPS port through screw cap and then tighten the
screw cap. Insert L1,L2,L3 wire, N wire and PE wire( PE wire does not applies to
Australia) into corresponding ports of EPS terminal and screw them tightenly.
Ø
Requirements for EPS loadØ
Make sure the EPS load power rating is within EPS output rating,
otherwise the inverter will shutdown with an “over load” warning.
When an “over load” is appeared, adjust the load power to make
sure it is within the EPS output power range, then turn the inverter
back on.
For the nonlinear load, please make sure the inrush power should
be within the EPS output power range.
Configuration current less than the maximum dc input current,
generally lithium and lead acid capacity and voltage are linear decline.
WARNING !
Below table shows some co loads for you reference.mmon feasible
Note:Please check with the manufacturer for high power inductive load.
Type
Power
Start
Rated
Common
equipment
Example
Resistive
load
Inductive
load
Capacitive
load
X 1
X 2
X 1
X 1.5
X 3~5 X 2
Start
Rated
100VA
(W)
100VA
(W)
80VA
(W)
60VA
(W)
450-750VA
(W)
300VA
(W)
Equipment
Fluorescent lamp
Fluorescent lamp
40W
Fan
Fridge Fridge
150W
Incandescent
lamp
TV Incandescent
lamp
100W
Electrical ConnectionElectrical Connection
28
29
for AU/NZ
for AU/NZ
Step2.
Note: Connect PE wire into
PE port at right side !
Note: The right most port
should not be connected !
Step1.
for other
countries
for other
countries
Table 5 Cable and Micro-breaker recommended
EPS Cable
≥5mm²
EPS breaker
≥5mm² ≥5mm² ≥5mm²
25A 25A 32A 32A
Model
X3-Hybrid-5.0-D
X3-Hybrid-5.0-N
X3-Hybrid-6.0-D
X3-Hybrid-6.0-N
X3-Hybrid-8.0-D
X3-Hybrid-8.0-N
X3-Hybrid-10.0-D
X3-Hybrid-10.0-N
L1
L2
L3
N
PE
60mm
12mm
L1
L2
L3
N
60mm
12mm
L1 L2 L3 N
PE
The screwdriver .
torque:1.2±0.1Nm
To Next Page
Loading...
