5. Installation
5.1 Check for Physical Damage
5.2 Packing List
Make sure the inverter is intact during transportation. If there is any visible
damage, such as cracks, please contact your dealer immediately.
Open the package and take out the product, please check the accessories first.
The packing list shown as below.
Installation Installation
Object
A
B
C
Inverter
Bracket
Expansion bolt (5)
Description
Installation Precaution
X3-Hybrid Series inverter is designed for outdoor installation (IP 65).
Make sure the installation site meets the following conditions:
Not in direct sunlight.
Not in areas where highly flammable materials are stored.
Not in potential explosive areas.
Not in the cool air directly.
Not near the television antenna or antenna cable.
Not higher than altitude of about 2000m above sea level.
Keep Dry-The package/product must be protected from excessive humidity
and must accordingly be stored under cover.
Under good ventilation condition.
The ambient temperature in the range of -20℃ to +60℃.
The slope of the wall should be within ±5°.
The wall hanging the inverter should meet conditions below:
1.solid brick/concrete, or strength equivalent mounting surface;
2.Inverter must be supported or strengthened if the wall’s strength isn’t
enough(such as wooden wall, the wall covered by thick layer of decoration)
Please AVOIDE direct sunlight, rain exposure, snow laying up during installation
and operation.
5.3 Mounting
18
19
A
B C D
E F G H
N
I
19
J
K
X3- Hybr id 5kW- 10kW
H
I
J
K
L
Ring terminal (for grounding) (2)
User manual
Quick installation guide
M
Warranty card
Waterproof connector with RJ45 (2*RJ45)
Grounding nut
N
O
P
WiFi module (optional)
L
M
P
Q
D
E
F
PV connectors (3*positive, 3*negative)
Battery connectors (1*positive, 1*negative)
PV pin connectors (3*positive, 3*negative)
G
AC terminals/EPS terminals (optional)/Earth terminals (12)
Q
8 pin terminal for meter connection
scotch tape(2)
NTC (optional)
O
To Next Page
Loading...
