Requirements for CV Tools!
Live 10 Suite (version 10.1 or later)
Live 10 Standard + Max for Live (version 10.1 or later)
A DC-coupled audio interface (for CV hardware integration) such as
the SSL 2+ MKII!
Some understanding of Ableton Live Packs
Some understanding of how to use CV-enabled hardware with Live
Best Practices & Safety
Never send CV directly to your speakers (direct voltage can cause
damage to your speakers).
The CV Instrument device is only capable of calibrating oscillators that
use bipolar voltage (+/-5V) for 1v/oct. tuning.! However, some digital
oscillator modules exclusively use unipolar signals (+5V or above) for
tuning.! As a result, CV Tools will be incompatible with these modules.!
If you are unsure whether this applies to the modules in your system,
please consult the user manual for the device.
Remember - Eurorack signals are up to 5x louder than line-level
audio! Before connecting your modular system to a digital audio
interface, be sure to reduce the signal down to line-level using a
dedicated output module.
Specifications
Audio Performance Specifications
Unless specified otherwise, default test configuration:
Sample Rate: 48kHz, Bandwidth: 20 Hz to 20 kHz
Measurement device output impedance: 40 Ω (20 Ω unbalanced)
Measurement device input impedance: 200 kΩ (100 kΩ unbalanced)
Unless otherwise quoted all figures have a tolerance of ±0.5dB or 5%
Microphone Inputs
Frequency Response: ± 0.1 dB
Dynamic Range (A-Weighted): 116.5 dB
THD+N (@ 1kHz): -100 dB / < 0.001 % @ -8 dBFS
EIN (A-Weighted, 150 Ω termination): -130.5 dBu
To Next Page
Loading...
