5
Step 1: Connect your phone to the data logger’s access point network
3. Configuration
Open your phone WiFi settings and look for the WiFi network that starts with “Solis_”
followed by the data logger serial number. Tap that network to connect to it. Enter the
password and then tap Join. This is the logger access point (AP) network.123456789
If you get a message stating that the password is incorrect or if the logger WiFi network
does not appear in the list of nearby networks, press and hold the Reset button on the
back of the data logger for 15 seconds.
If the AP network still does not appear or if the password fails again, contact Solis Support.
Configuration and Commissioning Overview
Connect phone to logger
access point network
Go to logger configuration
page on a browser app
Select the desired WiFi
network & enter password
Wait ten seconds for the
logger to communicate
Download SolisCloud and then
register a new account
Create a new plant for
the system on SolisCloud
On the new plant, go to
add a device
Scan the sticker
on the logger
Wait five to ten minutes
for the logger to report
Once the logger reports, the inverter(s)
will auto-populate into the new plant
The system has now been commissioned
Solis Support can be reached by calling +1(866)438-8408 or by
sending an email direclty to usservice@solisinverters.com
Please provide the support team with the data logger serial number,
inverter serial number, and a detailed description of the issue that
you are having. The support team will assist you in a timely manner.
.
Contacting Solis Technical Support
To Next Page
Loading...