To Next PageTo Next PageWhat to do if my SOLIS S5-GC125K-HV has no power?
If your SOLIS Inverter isn't powering on, verify the PV input connections are secure. Then, check the DC input voltage (it should be greater than 120V for single phase or greater than 350V for three phase systems). Finally, ensure that the PV positive and negative connections are not reversed.
General| Model | S5-GC125K-HV |
|---|---|
| Rated Power | 125 kW |
| Max. DC Input Power | 187.5 kW |
| Max. Input Voltage | 1100 V |
| Start-up Voltage | 250 V |
| MPPT Voltage Range | 200-1000V |
| Number of MPPTs | 10 |
| Rated AC Output Power | 125 kW |
| Max. AC Apparent Power | 137.5 kVA |
| Rated Grid Voltage | 400V |
| Grid Voltage Range | 320-480V |
| Rated Grid Frequency | 50/60 Hz |
| Grid Frequency Range | 45-55 Hz / 55-65 Hz |
| Power Factor | 0.8 leading to 0.8 lagging |
| THDi | <3% |
| DC Switch | Yes |
| Cooling Method | Forced air cooling |
| Protection Degree | IP66 |
| Weight | 86 kg |
| Efficiency | 98.7% |
| Maximum DC Input Power | 187.5 kW |
| Maximum DC Input Voltage | 1100 V |
| Maximum Input Current per MPPT | 26 A |
| AC Nominal Voltage | 400V |
| AC Output Frequency | 50/60 Hz |
| Maximum Efficiency | 98.7% |
| European Efficiency | 98.4% |
| Ingress Protection Rating | IP66 |
| Protection | DC reverse polarity, AC overcurrent, grid monitoring |
| Operating Temperature Range | -25°C to +60°C |
| Communication | RS485, Ethernet |
| Communication Interface | RS485, Ethernet |
Describes the Solis Three Phase Inverters and their function.
Explains symbols used for safety warnings.
Provides essential safety guidelines for installation and use.
General information on mounting the inverter to walls or racks.
Step-by-step instructions for wall mounting the inverter.
Step-by-step instructions for rack mounting the inverter.
Overview of all electrical connection types for the inverter.
Procedures for correctly grounding the inverter.
Steps for connecting the DC input from the PV array.
Instructions for connecting the inverter to the AC grid.
Verifying and setting the correct grid standard.
Procedure to confirm the grid standard.
Overview of how to change grid standard settings.
Step-by-step guide to setting the grid standard.
Verifying DC, AC connections and configuration before operation.
Step-by-step guide to safely start the inverter.
Step-by-step guide to safely shut down the inverter.
Technical settings for advanced users and maintenance.
Function to select the grid's reference standard.
Lists common alarm messages, failure descriptions, and solutions.
Detailed technical specifications for the 100K-5G model.
Detailed technical specifications for the 110K-5G model.
Detailed technical specifications for the 125K-HV-5G model.
