Preparing the equipment for use
ENGLISH 12
Model 107L/ 107B
Transport protection for metal cutting blades
(model 107L/ B)
When you first purchase an approved metal
cutting blade which is not supplied together with
the power tool (see chapter 12 "Accessories"), you
will also need to purchase a corresponding
transport protector.
When the metal cutting blades are attached (4-
tooth grass cutting blade or 3-tooth brush cutting
blade, provided either as standard equipment with
the different models or purchased as accessories),
the transport protector must always be attached to
cover the blades when the device is being stored
or transported, or during work breaks during which
the engine is switched off.
• Position the transport protector with the
corresponding recess at one of the tips of the
metal cutting blade.
• Press the two tabs (a) on the transport protector
together to increase the internal diameter of the
transport protector.
• Lay the transport protector right over the cutting
tool. Position the inner shoulder (b) between the
metal cutting blade and the running disc.
• Open the two tabs again, and in doing so also
position the inner shoulder between the metal
cutting tool and the running disc at tab (c).
When restarting work, take the transport protector
back off by pressing the two tabs (a) together
before starting the engine.
Dismantling the cutting tool
(model 107L/ B)
• With the engine off, turn the cutting tool until the
recess in the cup washer and the hole in the
gearbox casing are precisely one above the
other, and the locking pin can be inserted.
• Unscrew the cutting tool in an anti-clockwise
direction (left-handed thread).
[For metal cutting tools, undo the locking nut
using a suitable tool; for the line head, unscrew
directly by hand.]
Fig. 10
To Next Page
Loading...
