Accessories ; Guarantee
ENGLISH 23
12. Accessories
Via dealers, SOLO offers an extensive range of grass trimmer / brush cutter accessories. Their use is
limited to the particular model to which it is allocated, together with its relevant protection. Orientate
yourself on the following table and check with your dealer.
Model
Accessory Protection Part no.
104L
107L/B
2 nylon head semi-automatic M 10 x 1.25 RE
(grass, even around obstacles, light weeds)
Standard shield +
line trimming blade
69006505 X
2 nylon head semi-automatic M 10 x 1.25 LI
(grass, even around obstacles, light weeds)
Standard shield +
line trimming blade
69006375 X
Replacement line for nylon head 15m, Ø2.4 mm 6900942 X X
Spool of nylon cord 90 m, Ø2,4 mm 0063201 X X
Grass cutter blade 4 teeth, Ø230 mm
(grass, stronger weeds)
Standard shield
without protective bar
6900948 X
Brush blade 3 teeth Ø250 mm
(bushes, reeds, tough grass)
Standard shield
without protective bar
6900947 X
Transport protector for metal cutting blades up to
Ø250 mm
6073534 X
High performance gearbox grease 008318025 X
SOLO 2T engine oil 100 ml 0083103 X X
SOLO 2T engine oil 1 l 0083104 X X
SOLO 2T engine oil, in a metering bottle 1 l 0083105 X X
SOLO face/ear protection pack 993901002 X X
SOLO forest and countryside work jacket EN 340 99303000 + size (2[s] - 6[xxl]) X X
SOLO Outdoor Knee-breeches 9902095 + size X X
SOLO Outdoor dungarees 9902094 + size X X
SOLO leather forest boots 9930510 + size (36 - 48) X X
Gloves SOLO Fit 9939012 + size X X
13. Guarantee
The manufacturer guarantees trouble-free quality and will cover the cost of replacing parts which are found
to be faulty in material or workmanship within the prescribed guarantee period after the date of purchase.
Please note that specific guarantee conditions may vary from country to country. If in doubt, ask your
equipment vendor. He is responsible for guarantee matters.
We hope you will understand that we cannot be liable for damage resulting from the following causes:
• Non-compliance with the operating instructions.
• Neglecting essential maintenance and repair work.
• Damage caused by incorrect carburettor adjustment.
• Wear in normal use.
• Obvious overload by continuously exceeding the maximum performance limit of the product.
• Using non-authorised tools.
• Use of force, incorrect treatment, misuse and accidents.
• Damage from excessive heat due to dirt build-up around the cooling fan housing.
• Attempted adjustments and repairs by unqualified persons.
• Use of unsuitable spare parts or third party parts, if these are the cause of the defect.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the hire or rental industry.
Normal cleaning, adjustments or maintenance work fall outside the guarantee provisions.
A service centre authorised by the manufacturer must carry out all guarantee work.
To Next Page
Loading...
