Fuelling ; Starting / Stopping the engine
ENGLISH 10
6. Fuelling
6.1 Fuel information
A high performance two-stroke engine operated
with a petrol:oil mixture (petrol + oil = fuel mixture)
or with a special fuel mixture for two-stroke engines
available from specialists powers this machine. The
fuel mixture can be made up with standard lead-
free petrol or with lead-free premium grade petrol.
The minimum octane rating for petrol is 92 ROZ.
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Avoid direct skin contact with petrol and
avoid inhaling petrol fumes - health hazard!
6.2 Mixing ratio
Always use a oil : fuel ratio of 1:25 (4%) for the first
five tank fillings.
After that we recommend a ratio of 1:50 (2%) with
the use of special two-stroke oil "SOLO 2T engine
oil" which we can supply.
With the use of other brand two-stroke oils we
recommend a ratio of 1:25 (4%).
Never store fuel mixture longer than 3 - 4 weeks.
Fuel mixture table
Oil in litres Petrol in
litres
SOLO 2T engine oil
2% (1:50)
Other two-
stroke oils
4% (1:25)
1 0,020 0,040
5 0,100 0,200
10 0,200 0,400
6.3 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off.
Carefully clean the area around the filler inlet.
Place the machine with the fuel inlet pointing
upwards. Unscrew the tank lid and fill the fuel
mixture up to the lower edge of the filler neck. Use
a funnel with filter to prevent tank contamination.
After filling the tank replace the tank lid and
tighten firmly.
7. Starting / Stopping the engine
7.1 Half throttle start position
• Move the stop switch (1) to "ON".
• Grip the handle; the safety locking key (3) is
activated via the grip area, which also enables
throttle lever (2) to be regulated.
• Press throttle lever (2) fully down.
• Press the half throttle lock (4), and let the
throttle lever return, whilst holding the half
throttle lock in.
7.2 Choke and primer
Adjust choke (7) as follows:
• With a cold engine, position choke lever (7) up
towards "Close"
.
• With a warm engine, position choke lever (7)
down towards "Open"
.
When first starting or if the fuel tank has been
completely drained and has been refilled, press
primer (8) several times (at least 5x) until the fuel is
visible in the plastic bulb.
Fig. 7
Fig. 8
To Next Page
Loading...
