UM0025_ASW3000-6000H-S2_EN_V04_0624 5
2 Safety
2.1 Intended use
The product is a transformerless hybrid inverter with 2 MPP trackers and a battery connection that feeds the direct current
of the PV array into the connected battery or converts it to grid-compliant single-phase current and then feeds it into the
utility grid. The product also can convert the DC current supplied by the battery into grid-compliant single-phase current.
The product also can convert the AC current supplied by the grid into battery current.
The product has a backup function that can continue to supply selected circuits with power from the battery or PV system
in the event of a grid fault.
The product also can convert the direct current supplied by the battery into grid-compliant single-phase current.The
product is intended for indoor and outdoor applications.
The product must only be connected with PV modules of protection class II (in accordance with IEC 61730, application
class A). Do not connect any sources of energy other than PV modules and batteries to the product.
PV modules with a high capacitance to ground must only be used if their coupling capacitance is less than 1.5μF.
The product is not equipped with an integrated transformer and therefore has no galvanic isolation. The product must not
be operated with PV modules which require functional grounding of either the positive or negative PV conductors. This
can cause the product to be irreparably damaged. The product may be operated with PV modules with frames that require
protective earthing.
The inverters shall not be used in multiple phase combinations.
All components must remain within their permitted operating ranges and their installation requirements at all times.
Use the product only in accordance with the information provided in the user manual and with the locally applicable
standards and directives. Any other application maycause personal injury or damage to property.
The product must only be operated in connection with an intrinsically safe lithium-ion battery approved by AISWEI. The
entire battery voltage range must be completely within the permissible input voltage range of the product.
The product must only be used in countries for which it is approved by AISWEI and the grid operator.
Knowledge of all applicable laws, standards and directives.
Knowledge of and compliance with this document and all safety information.
The type label must be permanently attached to the product and must be in a legible condition.
This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that apply
to the installation, electrical safety and use of the product.
2.2 Important safety instructions
The product has been designed and tested strictly according to the international safety requirements. As with all electrical or
electronical devices, there are residual risks despite careful construction. To prevent personal injury and property damage and
to ensure long-term operation of the product, read this section carefully and observe all safety information at all times.
Danger to life due to high voltages of the PV array or the battery！
To Next Page
Loading...
