24
Boot Sequence Default is ÒA, C, SCSIÓ. This option
determines which drive to look for
first for an operating system.
Swap Floppy Drive Choose Enabled or Disabled
(default). This option swaps floppy
drive assignments when it is
enabled.
Boot Up Floppy
Seek
Enabled (default): During POST,
BIOS checks the track number of the
floppy disk drive to see whether it
is 40 or 80 tracks.
Disabled: During POST, BIOS will
not check the track number of the
floppy disk drive.
Boot Up NumLock
Status
Choose On (default) or Off. This
option lets user to activate the
NumLock function at boot-up.
Typematic Rate
Setting
Choose Enabled or Disabled
(default). Enable this option to
adjust the keystroke repeat rate.
Typematic Rate
(Chars/Sec)
Range between 6 (default) and 30
characters per second. This option
controls the speed of repeating
keystrokes.
Typematic Delay
(Msec)
Choose 250 (default), 500, 750, and
1000. This option sets the time
interval for displaying the first and
the second characters.
Security Option Choose System or Setup (default).
This option is to prevent
unauthorized system boot-up or use
of BIOS Setup.
To Next Page
Loading...
