Award BIOS Setup 37
Parallel Port EPP
Type
Choose EPP1.7 (default) or EPP1.9.
EPP1.9 supports hardware
handshake. This setting is
dependent on your EPP device.
Note: The above 2 options will not
be displayed unless the
EPP/ECP function is selected.
3. Press <ESC> and follow the screen instructions to save or
disregard your settings.
Supervisor/User Password
These two options allows you to set your system passwords.
Normally, supervisor has a higher right to change the CMOS
setup option than the user. The way to set up the passwords
for both Supervisor and User are as follow:
1. Choose ÒChange PasswordÓ in the Main Menu and press
<Enter>. The following message appears:
“Enter Password:”
2. The first time you run this option, enter your password
up to only 8 characters and press <Enter>. The screen
does not display the entered characters.
3. After you enter the password, the following message
appears prompting you to confirm the password:
“Confirm Password:”
4. Enter exact the same password you just typed again to
confirm the password and press <Enter>.
5. Move the cursor to Save & Exit Setup to save the
password.
6. If you need to delete the password you entered before,
choose the Supervisor Password and press <Enter>. It
will delete the password that you had before.
To Next Page
Loading...
