36
UART2 Mode Choose Standard (default), HPSIR,
or ASKIR.
IR Function
Duplex
Choose Half (default), or Full.
Half: DoesnÕt transmit and receive
activities at the same time.
Full: Transmit and receive
activities at the same time.
RxD, TxD Active Choose Hi/Hi, Hi/Lo, Lo/Hi, or
Lo/Lo (default).
¥: The above 2 options will not work
unless UART2 Mode
HPSIR/ASKIR is selected.
Onboard Parallel
Port
Choose the printer I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5
Parallel Port Mode Choose SPP (default), ECP/EPP,
EPP/SPP, or ECP mode. The mode
depends on your external device
that connects to this port.
ECP Mode Use
DMA
Choose DMA3 (default) or DMA1.
Most sound cards use DMA1.
Check with your sound card
configuration to make sure that
there is no conflict with this
function.
*: This option will not be displayed
unless the EPP/ECP function is
selected..
To Next Page
Loading...
