SOMFY LT RTS CMO - Adding or Deleting Sensors; Resetting Motor Memory; Resetting for New Transmitter

The end-product jogs briefly UP/DOWN
indicating that the LT RTS CMO motor is in
PROGRAMMING STATE.
The end-product jogs briefly UP/DOWN
If it is a new sensor:
If the sensor was previously recorded:
it will be recorded in the motor.
it will be deleted.
The end-product jogs briefly UP/DOWN
The memory of the receiver is cleared (all the previous
sensors are erased) and the new sensor is recorded.
Press for more than 2 seconds on the
programming button of an RTS transmitter/
channel which is already recorded in the motor.
Press BRIEFLY on the programming button
of the SOLIRIS RTS .sensor
Press for more than 7 SECONDS
on the programming button of the
new SOLIRIS RTS .sensor
4) Add or Delete an EOLIS or SOLIRIS Sensor RTS in the memory of LT RTS CMO motor
a) Enter the "PROGRAMMING STATE"
b) To record or delete a sensor
c) To Erase all the sensors and record a new one
LT RTS CMO motors will memorize up to 3 RTS Sensors
-
+
-
+
-
+
-
+
>2 Seconds
>7 Seconds
5) Resetting the motor's memory and recording a new
transmitter when the only transmitter is lost.
A.** Perform a power cut in the following sequence:
1. Power-off - 2 sec. Minimum
2. Power-on - 5 to 15 seconds
3. Power-off - 2 sec. minimum
4. Power-on
The end product moves for 5 seconds in one direction,
to indicate that the double power cut has been recorded.
The motor is in INSTALLER MODE for 2 minutes.
WARNING: This type of power cut affects all
the LT RTS CMO motors on the same power line.
To avoid resetting of non-concerned
motors, press briefly any button of their assigned
transmitter/channel. (UP, STOP, or DOWN)
The non-concerned motors will exit INSTALLER
MODE and return to USER MODE.
**RESETTING MOTORS BACK TO USER MODE
B.
NOTE:
Press more than 5 seconds on the programming button of the
NEW RTS transmitter. The end-product jogs briefly UP/DOWN
indicating that the transmitter has erased the previous
and recorded the new one.transmitter
A double power cut cannot be achieved if the motor
is still in FACTORY or INSTALLER Mode. First program a
transmitter into the memory of the motor.
>5 sec.
NEW TRANSMITTER
5 seconds
!
Transmitter
previously
recorded
!