Soliris io
3 modes in io ecosystem depending of your installation and receivers paired
⚫ Mode 1:
▪ actuators are paired directely at the soliris io sensor
▪ Only 1W remote control is used & paired
▪ Wind and sun settings should be done localy
▪ Sensor behaviour is directed by SOMFY recommendations (see appendix)
⚫ Mode 2 (available in 2021):
▪ Intelligents motors are paired at the soliris io sensor (as pergola box unit)
▪ Only one way remote control is used & paired
▪ The intelligents motors used the raw datas from the sensor to react: the behaviour is directed by
intelligents motors
⚫ Mode 3 (available in 2021):
▪ 2 way remote control like TaHoma is used & paired
▪ Sensor behaviour, only sun and rain in comfort is directed by scenarios in TaHoma by end user
▪ Wind behaviour is directed by SOMFY directly to actuators paired.
8
To Next Page
