SOMFY Soliris User Manual

Mains
Telis soliris RTS
Soliris sensor
Soliris receiver RTS
Connect the cable
to the terminal.
Put the
cover
Fix the sensor
to the wall.
Put and screw
the front box.
,y
,,yy
,y
,,yy
PRINCIPLE DIAGRAM
ADD A NEW CONTROL IN THE MEMORY OF A RECEIVER
(ONLY WITH RTS CONTROL)
2
B
Programming :
GENERAL OR GROUP CONTROL
• Set all the SOLIRIS receiver RTS you wish to control by one RTS
control in their programming mode.
• Press shortly the programming button of the RTS control.
➭ The LEDs of all the SOLIRIS receiver RTS blink indicating that the address of the RTS control
is memorized in all these receivers.
INITIAL INSTALLATION
1
with an RTS control (TELIS soliris RTS ; Centralis RTS ; TELIS 1 or 4 RTS).
with an INIS RT.
Remove and replace the battery of the
INIS RT, then Press shortly the push but-
ton on the INIS RT.
+
F D K
LIT
H
IU
M
B
A
TT
E
R
Y
C
R
2430
3V
+
F D K
LITHIUM BATTERY
CR 2430
3V
Inis RT
The LED of the
SOLIRIS recei-
ver RTS blinks
indicating that
the address of
the INIS RT is
memorized in receiver which automa-
tically quits its programming mode.
NNL
▲
▼
SC
you can only program one INIS RT in the memory of a receiver (single control).
you cannot program INIS RT and RTS controls together in the memory of a receiver.
Set the SOLIRIS receiver
RTS in its programming
mode by pressing the
PROG button until the
LED lights.
This indicates that the SOLIRIS
receiver RTS is ready to receive the address of a control for
one minute (After this time limit, the LED will go out).
NNL
▲
▼
SC
Press shortly
the program-
ming button
on the RTS
control.
MULTIPLE CONTROL
• Assign several RTS controls to the SOLIRIS receiver RTS following the
same procedure as described above.
You can assign up to 16 controls to one receiver. If you try to enter a
17th,your instruction will be ignored, the led of the receiver will go out.
The LED of the
SOLIRIS receiver
RTS blinks indi-
cating that the
address of the
RTS control is
memorized in receiver which automati-
cally quits its programming mode.
Press more than 2 seconds on the
programming button of a RTS control
which is already memorized in the
SOLIRIS receiver RTS in order to
“wake up” the SOLIRIS receiver RTS.
➭ the LED of the RTS control lights on, indica-
ting that all the SOLIRIS receivers RTS which
have the adress of this control are in their programming mode for one minute.
Press shortly the programming button of
the new RTS control you wish to assign.
➭ The address of this control is memorized in all the
SOLIRIS receivers RTS which automatically quit their
programming mode.
3V
LITHIUM
CR2430
+
NNL
▲
▼
SC
Set the SOLIRIS
receiver RTS in its
programming mode
by pressing the
PROG button until
the LED lights.
This indicates that the SOLIRIS receiver RTS is ready to
receive the address of a control for one minute (After this
time limit, the LED will go out).
NNL
▲
▼
SC
➭
MOUNTING OF THE SOLIRIS SENSOR

SOMFY Soliris Specifications

General

Brand	SOMFY
Model	Soliris
Category	Receiver
Language	English